Comes in a set of 6, oxygen clean
Tighten to 10 ft/lbs*
* never when pump is cold
Complete New Cold End Assembly for most horizontal cryogenic pumps (1.0" Piston). Clean for oxygen service. Comes with plate gasket and installation instructions.
Includes the following parts:
Expander Ring, CV Cold End 1.0". Set of 3
Reference # 10506-1
Copper Gasket for the discharge port of most horizontal pumps: CV, NDPD, DPD, SDPD, LXR
This teflon hat seal is made to fit 1.0" diameter piston cryogenic pumps including: CV, LXR, DPD, NDPD, SDPD, WDPD
Includes Cold End Assembly, set screw and suction plate gasket. Every cold end comes with all new soft goods, inspected or replaced major components and a fresh vacuum insulation.
If the returned cold end assembly is not...
NDPD 1.0" COLD END SEAL KIT
Includes a NDPD style 1.2" bore cold end and a NDPD 1.26" stroke drive end assembly, New, clean for Oxygen service and bearings packed with Krytox oxygen compatible grease
45158-1 Drive Assy 1.26”
35779-1 Cold End 1...
Silicon O-Ring, for 1.0" Piston on most horizontal cold ends
Use this tool when replacing the piston rings and rider rings on your horizontal cryo pump. This will allow you to safely install the piston into the chamber without damaging the rings.
Set of 3 Piston Rings for a 1.0" Piston horizontal cryogenic reciprocating pump, common to LXR, CV, DPD, NDPD, WDPD, SDPD, etc. Clean for Oxygen Service